![]() ![]() This is a welcome update as it was lacking in previous versions of this product. It’s housed in the oval shaped blob in the middle of the cord leading to the adapter. I should also mention at this point, that the power brick included with this adapter, has an ON/OFF switch built into the cable. Again, both drives worked fine when connected in this manner. Files could be copied back and forth between the drives and back and forth between my desktop computer.Ī much more tidy configuration is pictured here with the same SATA drive and a 40gb Toshiba IDE. Even though it looks sorta messy, both drives mounted and worked as expected. The Y power cable was also needed for this particular setup. It may be hard to discern in the image, but I had to use the female to male IDE extended cable to connect the IDE drive to the adapter due to the fact that the SATA drive obstructed the 40-pin IDE connector. In the image above, you will see that I have an 80gb Hitachi SATA drive and a 80gb Western Digital IDE drive connected to the adapter at the same time. Another tidbit to remember is that 1.8 and 2.5 inch IDE drives can run by USB juice alone. Just plug the included power brick into the adapter and you’ll be fine. That could result in bad bad things happening to your drive. The main thing you should remember, is to NOT connect power to an SATA’s 4-pin power connector AND the power connector on the adapter. The status LEDs show Power, Read/Write activity and SATA connectivity.Ĭonnecting the adapter to your drives is not rocket science, but there are a couple of important things to be aware of that the included instruction sheet fails to mention. The button initiates the one touch backup feature (more about that in a bit). The new adapter is a 3.0 x 2.5 x 0.5 inch plastic box, that has 1 button, 3 status LEDs and 5 connectors. One look at the new design of the main adapter revealed a built in power connector for the SATA connection. This first thing I noticed when I opened the box, was the fact that there weren’t as many cables included with this version of the product. USB 2.0 To SATA/IDE Adapter With One Touch Backup SATA Interface: High speed data transfer rates up to 1500Mb/secĪTA/ATAPI: Support 16-bits DMA and Ultra DMA mode interface (Ultra 33/66/100/133)ĭual Mode: Support bisynchronous mode, compatible to SATA and IDE device simultaneously Supports IDE and enhanced IDE hard drives up to 500GB ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |